Home     WIKUS Partner Portal     Download     Contact    

16.11.2018 06:31:42

Home     WIKUS Partner Portal     Download     Contact    

16.11.2018 06:31:42

Home     WIKUS Partner Portal     Download     Contact    

BREAKING IN YOUR BAND SAW BLADES

Sharp cutting edges that have extremely small edge radii are the ideal prerequisites for high cutting ability and a long service life. This is ensured by breaking in the blades properly. See pictures above:

  1. New cutting edge with a very small edge radius
  2. Proper breaking in of the band saw blade creates a stable cutting edge
  3. Excessive strain due to improper breaking in leads to micro-breakages of the cutting edge

 

Before you use them for the first time:

BIMETAL BAND SAW BLADES

  • Determine the right cutting speed and feed rate (using the WIKUS bimetal cutting data slide rule, for instance) based on the material to be cut and its dimensions.

  • Important: Use a new blade with approx. 100% of the cutting speed (m/min) and approx. 50% of the feed rate  (mm/min)

 

CARBIDE BAND SAW BLADES

  • Determine the right cutting speed and feed rate (using the WIKUS carbide cutting data slide rule, for instance) based on the material to be cut and its dimensions.
  • Important: Use a new blade with approx. 75% of the cutting speed (m/min) and approx. 50% of the feed rate (mm/min)
  • Very important: band saw blades can be prone to vibration and vibration noise - Help: To resolve this issue, reduce the cutting speed (m/min) once again

 

  • With small workpiece dimensions, approx. 300 cm² of the material should be cut to break in the blade.
  • With large workpiece dimensions, we recommend breaking in over a period of about 15 min.
  • After breaking in, slowly increase the cutting speed (m/min) to the determined value and then gradually increase the feed rate (mm/min) to the value that you determined before.
WIKUS respects your data privacy
WIKUS uses cookies in order to offer you the best possible service and optimise functions for you. By continuing to use the website, you agree to the use of cookies. You also have the option to customise the use of cookies to suit your needs.
Adapt cookies
Accept and close